How to Edit a wave

Selecting blocks

1. To select a block of audio, hold down the control key and click the mouse button where you want to begin selecting.
2. Without releasing the mouse button move the mouse over the wave file until you reach the spot you want your selection to end.
3. Now release the mouse button and your selection will be highlighted. You can adjust your selected audio by clicking on the ends of the selection and moving the cursor left or right.

Deleting and cutting blocks

1. Select the block of audio you want to delete.
2. After you highlight the block, go to the edit menu and click cut.

Copying blocks

1. Select the block of audio you want to copy.
2. After you highlight the block, go to the edit menu and click copy.

Pasting Blocks

1. Copy or cut the block of audio you want to paste.
2. Depending on how you want to paste the information, there are different paste commands you can choose.
   • Paste Insert inserts the audio at the point you specify.
   • Paste Over acts as a mixing effect, becuase you can paste audio over itself.
   • Paste Fill is a tool that lets you select a block of audio and paste your data only into that block.
   • Save Paste Buffer lets you save the information that you are waiting to paste, into a wave file so that you can use it later.

Tell a friend about DART
DART, Digital Audio Restoration Technology,
is a registered trademark of DARTECH, Inc. a subsidiary of ZH Computer, Inc.
Copyright © 1998-2008, DARTECH, Inc. All Rights Reserved
Privacy Information
DartPro Home page